Pratley has a wide range of versatile and cost-effective DIY adhesive products for a range of quick, on-the-spot automotive repairs. The products are ideal for areas where engineering workshops are sometimes unavailable, such as in rural towns or villages. Below is an easy step-by-step guide to repair a vehicle sump using Pratley products.

A person working on a car

Description automatically generated

What you need

Quickset® Putty features

 

Step-by-Step instructions

Step 1

Remove any dirt, rust, or oil. Use Pratley Safety Cleaner to flush out any remaining oil or grease. Remove any oil, grease, or dirt on the outside of the sump. Ideally, use Pratley Safety Cleaner to flush out any remaining oil or grease. Industrial-grade acetone can also be used.

 

A finger pointing at a black plastic box

Description automatically generated

 

Step 2

Sand the area around the crack to assist with the adhesion of Pratley Quickset® Putty. Clean the surface after sanding to further assist with adhesion.

Step 2

Step 3

Drill two small holes on either side of the crack to prevent it from spreading further.

A person using a drill to clean a metal surface

Description automatically generated

Step 4

Carefully read the packaged instructions before using Pratley Quickset® Putty. For convenience, the instructions are provided in isiZulu, Sesotho, English, Afrikaans, Portuguese and French.

A finger pointing at a piece of paper

Description automatically generated

Step 5

As per the instructions, cut equal parts of each stick and roll the parts together into a sausage form and then roll it into a ball. Repeat the process until there is a uniform cream colour throughout, with no streaks.

A person holding a piece of white material

Description automatically generated

Step 6

Knead and wipe the putty onto the surface around and over the crack. Build up with additional putty until the surface is covered.

Step  6

Step 7

Smooth off the putty with a wet finger and wipe off excess with a damp cloth. Repeat this process for the outside of the sump.

Step 8

Pratley Quickset® Putty will reach 75% strength in about four hours. Once set, it can be sanded smooth or painted to match any required colour (if required).

Step  8

 

Watch the how to video below: 

https://www.youtube.com/embed/FrwYmrCVN64?si=TZDeEG3KB2dD2kTc